作者单位
摘要
西南交通大学材料科学与工程学院材料先进技术教育部重点实验室,四川 成都 610031
界面金属间化合物的厚度和种类是影响铝/钢异种材料激光熔钎焊接头性能的关键。研究了不同摆动参数下接头金属间化合物(IMCs)的厚度和种类,并进一步分析了不同摆动参数下接头的拉伸性能及断口形貌。结果表明,摆动激光可以改善铝/钢异种材料激光熔钎焊接头界面金属间化合物的厚度和相组成。未加摆动激光时,在界面形成了厚度约为8.45 μm的两层IMCs,焊缝侧IMCs为τ5-(Fe,Ni)1.8Al7.2Si,钢侧IMCs为θ-(Fe,Ni)(Al,Si)3。当激光摆动直径为2 mm、频率为30 Hz时,IMCs的分布更加连续均匀,厚度约为2.21 μm,界面层组织为τ5-(Fe,Ni)1.8Al7.2Si,最优接头线载荷为289.1 N/mm,比未加摆动激光时的接头线载荷提高了约33.9%。
激光技术 铝/钢激光熔钎焊 摆动激光 金属间化合物 力学性能 
中国激光
2024, 51(12): 1202105
作者单位
摘要
西南交通大学材料科学与工程学院,四川 成都 610031
Inconel690镍基合金具有良好的综合力学性能,其焊接结构已经被广泛应用于核电产业中,通过改变热输入与填丝可以改善其焊接接头的力学性能。对Inconel690镍基合金与SUS304不锈钢进行激光对接焊试验,分析接头显微组织和力学性能。研究发现,焊缝呈现激光焊接典型的高脚杯形状,焊缝区域弥散分布含钛相。当未填充焊丝时,低热输入(1.5 kJ/cm)接头与高热输入(2.6 kJ/cm)接头相比,焊缝晶粒尺寸减小约40%,接头抗拉强度提高约9.7%,焊缝平均硬度提高约7.7%。在填充焊丝后,焊缝中Ni元素含量提高,Fe元素含量下降,出现弥散分布的富铬相,结合X射线衍射(XRD)结果分析,推测其为Cr0.19Fe0.7Ni0.11相。与高热输入接头相比,低热输入填丝焊的焊缝平均硬度与接头抗拉强度均有所提高,其中焊缝平均硬度提高约22.6%,抗拉强度提高约16.2%。
激光光学 异种材料 镍基合金 激光焊接 热输入 力学性能 
光学学报
2023, 43(10): 1014001
作者单位
摘要
西南交通大学材料科学与工程学院材料先进技术教育部重点实验室,四川 成都 610031
选用6 mm厚低碳贝氏体钢板进行激光-MAG复合焊接(MAG焊,熔化极活性气体保护电弧焊),以激光功率、焊接速度、送丝速度为试验参数,以焊缝成形系数(ψ)、激光区面积比(R)为响应指标,建立响应面分析数学模型。送丝速度对ψR的影响显著,激光功率与焊接速度的交互作用对ψ的影响显著,送丝速度与焊接速度的交互作用对R的影响显著。对焊缝成形进行评定,筛选出最优工艺参数:激光功率4120~4300 W,焊接速度15.3~16.3 mm/s,送丝速度12.3~13.6 m/min。经试验验证,ψR的模型准确度分别为95.0%和92.3%。
激光技术 激光-MAG复合焊接 低碳贝氏体钢 响应面法 成形系数 激光区面积比 
中国激光
2022, 49(16): 1602018
Author Affiliations
Abstract
1 State Key Laboratory of High Field Laser Physics, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai 201800, China
2 MOE Key Laboratory of Advanced Micro-structured Materials, Institute of Precision Optical Engineering, School of Physics Science and Engineering, Tongji University, Shanghai 200092, China
3 IFSA Collaborative Innovation Center, Shanghai Jiao Tong University, Shanghai 200240, China
4 Center for Optics, Photonics and Laser (COPL), Laval University, Quebec City, Quebec G1V 0A6, Canada
Sub-picosecond chirped laser pulse-induced airflow and water condensation were investigated in a cloud chamber. The results indicate that the positively chirped sub-picosecond laser pulses generate a more uniform intensity distribution inside the plasma column, leading to a weaker airflow and an elliptic-shaped snow pile. The negatively chirped sub-picosecond laser pulses generate a spark-like intensity distribution inside the plasma column, which produces a wider range of airflow and a round snow pile. The amount of snow weight and the concentration of NO3 are found to be dependent on the intensity distribution inside the plasma column. The visibly stronger plasma column generates much more snow and a higher concentration of NO3 . These experimental results provide a reference for sub-picosecond laser-induced water condensation in realistic atmospheric conditions.
140.3450 Laser-induced chemistry 320.7110 Ultrafast nonlinear optics 010.3920 Meteorology 
Chinese Optics Letters
2018, 16(6): 061403
Author Affiliations
Abstract
1 MOE Key Laboratory of Advanced Micro-structured Materials, Institute of Precision Optical Engineering, School of Physics Science and Engineering, Tongji University, Shanghai 200092, China
2 State Key Laboratory of High Field Laser Physics, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai 201800, China
3 IFSA Collaborative Innovation Center, Shanghai Jiao Tong University, Shanghai 200240, China
4 Center for Optics, Photonics and Laser (COPL), Laval University, Quebec City, Quebec G1V 0A6, Canada
We report on the experimental observation of the airflow motion induced by an 800 nm, 1 kHz femtosecond filament in a cloud chamber filled with air and helium. It is found that vortex pairs with opposite rotation directions always form both below and above the filaments. We do not observe that the vortices clearly formed above the filament in air just because of the formation of smaller particles with weaker Mie scattering. Simulations of the airflow motion in helium are conducted by using the laser filament as a heat source, and the simulated pattern of vortices and airflow velocity agree well with the experimental results.
140.0140 Lasers and laser optics 190.0190 Nonlinear optics 320.0320 Ultrafast optics 
Chinese Optics Letters
2016, 14(3): 031401
Author Affiliations
Abstract
1 State Key Laboratory of High Field Laser Physics, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, China
2 Centre d’Optique, Photonique et Laser (COPL) and D′epartement de physique, de g′enie physique et d’optique, Universit′e Laval, Qu′ebec, Qu′ebec G1V 0A6, Canada
We report on a systematic experimental study on the fluorescence spectra produced from a femtosecond laser filament in air under a high electric field. The electric field alone was strong enough to create corona discharge (CD). Fluorescence spectra from neutral and ionic air molecules were measured and compared with pure high-voltage CD and pure laser filamentation (FIL). Among them, high electric field assisted laser FIL produced nitrogen fluorescence more efficiently than either pure CD or pure FIL processes. The nonlinear enhancement of fluorescence from the interaction of the laser filament and corona discharging electric field resulted in a more efficient ionization along the laser filament zone, which was confirmed by the spectroscopic measurement of both ionization-induced fluorescence and plasma-scattered 800 nm laser pulses. This is believed to be the key precursor process for filament-guided discharge.2011CB808103), the Chinese Academy of Sciences and the State Key Laboratory of High Field Laser Physics, the 100 Talents Program of Chinese Academy of Sciences, and theShanghai Pujiang Program.
femtosecond laser filamentation femtosecond laser filamentation filament induced fluorescence spectroscopy filament induced fluorescence spectroscopy laser guided discharges laser guided discharges 
High Power Laser Science and Engineering
2016, 4(1): 010000e8
Author Affiliations
Abstract
State Key Laboratory of High Field Laser Physics, Shanghai Institute of Optics and Fine Mechanics, Chinese Academy of Sciences, Shanghai 201800, China
Filamentation-induced water condensation and snow formation are investigated using laser pulses with different chirps and pulse widths. Chirped pulses result in the laser filamentation with different spatial lengths and intensities, which has a great impact on airflow motion and snow formation. The experiments show that snow formation mainly relates to the filament intensity distribution. Negative chirped pulses produce a greater amount of snow because of higher intensity inside the filaments as compared with the positive chirped pulses.
320.0320 Ultrafast optics 190.0190 Nonlinear optics 140.0140 Lasers and laser optics 
Chinese Optics Letters
2015, 13(3): 033201
作者单位
摘要
1 东莞理工学院计算机学院, 广东 东莞 523808
2 东莞职业技术学院计算机工程系, 广东 东莞 523808
3 北京市气象局气候中心, 北京 100089
在传统的基于表面积的图像分形维数计算中,不同尺度下的表面积计算均在原图像中进行。这与图像细节随空间尺度的变化而变化的事实不符,据此计算的同类地物的分数维变化范围较大,对基于分形的图像分割、分类产生不利影响。针对这一问题,提出一种基于面积加权的快速插值算法来模拟不同尺度下的遥感图像,进而计算图像的分数维。实验结果表明,对于大小为512 pixel×512 pixel的标准Lena图像来说,新算法的插值速度提高10倍以上,且得到的分数维具有更小的类内方差以及更好的抗噪性,因而更适用于基于分形的遥感图像分割、分类。
图像处理 分形 加权插值 纹理图像 图像分割 
激光与光电子学进展
2013, 50(9): 091001

关于本站 Cookie 的使用提示

中国光学期刊网使用基于 cookie 的技术来更好地为您提供各项服务,点击此处了解我们的隐私策略。 如您需继续使用本网站,请您授权我们使用本地 cookie 来保存部分信息。
全站搜索
您最值得信赖的光电行业旗舰网络服务平台!